DropSaw Trimmers

DropSaw Trimmers are used in applications where trims in 1 or 2 feet increment are required. The machines consists of a heavy duty bottom feed table with lugged chains. Cross over even ending rollers are an option.

The machine consist of:

• Heavy duty feed table
• Optional even ending section
• Heavy duty saw box
• 1 or 2 foot saw spacing
• Optional dust collecting hookup
• Variable feed drive
• Optional intergration with an optimizer
• Plc controls

DropSaw Trimmers:
Saw increments of 1 foot

These machines are used in applications where a trim in 1 foot increments is required.

It allows slashing pieces out of the middle, trimming a bad end, or cutting a piece in two where one half might be a finished board and the second half needs to be remanufactured.

DropSaw Trimmers:
Saw increments of 2 feet.

These machines are used in applications where a trim in 2 foot increments is required, or with an optional saw at the one foot mark. The top saws are mounted on a heavy duty cross member. A standard saw frame with a motor and belt drive guarantee a trouble free operation.

Miniature trimmers for cedar and fencing industry with saw increments of 1 foot. These machines are used in applications where a possible trim at every 1 foot increment is required, trimming light material such as 1 x 4 cedar or pine. Its maximum capacity is 4” thick x 6” wide boards.

The standard machines are built for 10 foot lumber and are available for shorter or longer length as well. Each saw is mounted on a saw arbor with standard unit block bearings. A 3 hp motor is used for each saw. The saw assemblies are mounted on a heavy duty cross member.

The saws are controlled by the operator, and a PLC controller that will automatically pick the next shortest even 1 foot increment on the board is an option. -