Vertical Arbor Resaw

These machines are generally used in combination with a board edger for processing round back slabs and for lumber remanufacturing. Depending on the application we offer single or double arbor machines with up to 250 fpm feed rate using strobe saws or thin kerf guided machines with feed rates up to 450 fpm. On all machines the saws are height adjustable, controlled either by an operator or an optimizer.

Vertical Single Arbor Strobe Resaws

The single vertical arbor strobe machine will handle pieces up to 6" wide and is available with a single or double saw set up. The infeed to the resaw is usually the tailing device for the edger as well. The feed table consists of a chain bed with an electric motor drive and a series of top hold down rollers to ensure a positive feed. Vertical outfeed rollers eliminate pinching of the saws. The saw unit is a tube style arbor arrangement. The saw arbor slides vertically in a heavy duty bushing. The saws are set either by linear positioning set works cylinders or by stacked cylinder set works. The set works are assisted by an additional air cylinder to allow quick and easy shifting of the saws.

Vertical Double Arbor Strobe Resaws

The double vertical arbor resaw will handle pieces up to 8" wide and is also available with a single or double saw set up. As with the single arbor machine the infeed to the resaw is usually the edger tailing device. The feed table consists of a chain bed with an electric motor drive and a series of top hold down rollers to ensure a positive feed. Vertical outfeed rollers eliminate pinching of the saws. The saw unit is a tube style arbor arrangement. The saw arbor slides vertically in heavy duty bushings. The saws are set either by linear positioning set works cylinders or by stacked cylinder set works. The set works are assisted by an additional air cylinder to allow quick and easy shifting of the saws.

Vertical Single Arbor Thin kerf Guided Resaws

The single arbor guided machine will handle pieces up to 6" wide with a single or double saw set up. The saw is equipped with front and back babbitt guides that allow a feed rate of 450 fpm. The back guides assist in removing the top slivers of round back slabs The infeed consists of a set of four fixed vertical rollers and as set of two press rollers The out feed has a set of four fixed vertical rollers and as set of two press rollers The saw unit has one fixed arbor with a # 3 1/2" Retech spline, and a vertically shifting guide unit with either a stacked cylinder or linear positioning set works. The guide system on both the front and back allows a feed rate of up to 450 fpm.